Most of the off -road motorcycles were delivered to the store because the owner did not carry out maintenance on time. In most cases, the most basic maintenance of the car in the best state is ignored. Therefore, the time that could have been used to drive motorcycles and installed cool accessories and parts was wasted in the process of waiting for the maintenance of the car. Conventional maintenance can extend the service life of off -road motorcycles. How can we extend the life of motorcycles? Everything is attributed to ensuring that your car can get the correct conventional preventive maintenance. There are nine techniques here, which can allow your motorcycle to run in the best state.
1. Change the oil frequently. This may be the most important preventive maintenance you can do. The oil is the blood of the engine. The oil can help internal components lubricate, cool down, clean, seal, and prevent rust, which can minimize friction. Over time, the oil will contaminate pollutants and water, and the effectiveness will be reduced. Machine oil can make the top or bottom of the car have grasp.
2. Adjust or lubricate chain. Give your car chain lubricating oil to prevent rust. A rusty car chain will increase the difficulty of the engine to drive the wheel and offset a large part of the engine horsepower. Should be cleaned, maintained, and adjust your car chain. Otherwise, it will become loose over time, leaving from the chain gear of the car. Causes unnecessary economic losses and potential safety hazards.
3. Check the large and small chain teeth. Check the chain teeth to see if there are deformed or this broken sawtooth or other wear. You only need to pull out from the back of the sprocket. If the gap exceeds a quarter of feet, you need to change the chain tooth.
4. Check the bearings, lubricate if necessary. The most important thing is that you need to lubricate every mobile part of your car. Every year, you need to swing your swing arm bearings, rotation and wheels to lubricate one or two times. Otherwise, the bearings will be stuck, and the slider and wheels cannot be driven.
5. Adjust the valve. The valve will become tight over time. If the valve becomes tight, the heat may cause the valve or the piston to melt the cylinder wall and melt each other. So, regularly adjust the valve.
6. Keep the air filter clean. Like you, your motorcycle needs fresh air to survive. The dirty air filter can cause the engine to absorb accumulation, such as dirt. When these particles are rolled into the moving parts, the parts will wear prematurely or even damaged. Therefore, you need to clean the air filter, spray empty filtration, and then reinstall it. If you are playing the desert, I suggest you put on the sand prevention net!
7. Maintenance and exhaust. The blocking pipeline will increase the difficulty of the engine exhaust and reduce power. This will also make it difficult for the car to start. Therefore, ensure that the pipeline will not be blocked, rust, excessive oily, and the exhaust pipes are not damaged and the air leaks.
8. Lubrication. The rusty line will not only shorten the life of motorcycles, but also a significant safety hazard. Especially rusty brakes and throttle lato. Simple regular lubrication cables can prevent rust.
9. Clean your motorcycle. Develop good habits, cleaning your motorcycle can effectively prevent dirt from being involved in the part of the activity. This is the simplest preventive maintenance, which can check some minor problems.
